TRAPP TRF 50 Manual De Instrucciones página 49

www.trapp.com.br
Model
TRF 50
TRF 70
TRF 80
TRF 80F
TRF 80G
TRF 90
TRF 300
TRF 300F
TRF 300G
TRF 400
TRF 400F
Some shredder models are provided with 110/220 V
voltage selector.
Note:
If necessary, the motor protection cover

(according to the figure beside) can
be removed. Some shredder models
with electric motor installed directly in
the shredder's body, allow the motor
protection removal so as to allow
cleaning the residues accumulated inside
the motor protection, resulting from the
dust generated during the work. The
electric motors protected by a sheet
(IP22) and gasoline-powered engine can
be cleaned by using compressed air.
Such work must be conducted with
the equipment off and wearing safety

glasses. Never operate the equipment
without the factory-supplied protections.
0.8 mm 2 mm
- -
2122-336 -
2122-334 -
- -
2122-334 -
2122-334 -
2122-337 -
2122-337 -
2122-337 -
2122-337 -
2122-337 -
Voltage Selector Switch
Sieve codes
3 mm 5 mm
2122-342 2122-341
2122-342 2122-341
2122-332 2122-331
2122-332 2122-331
2122-332 2122-331
2122-332 2122-331
2122-308 2122-309
2122-308 2122-309
2122-308 2122-309
2122-308 2122-309
2122-308 2122-309
If necessary, adjust the motor voltage according
to the locally available power grid voltage, by
adjusting the selector as indicated in the figure.
Motor
protection
cover
Screw
Voltage
selector
switch
In order to adjust the voltage selector, it's not
necessary to open the motor protection cover, just
remove the acrylic cover located in the voltage
selector and by using a screwdriver, change the
position as desired, in order to change the selector
position, move the screwdriver parallel to the
motor.
12 mm Smooth
2122-340 -
2122-340 -
2122-333 2122-330
2122-333 2122-330
2122-333 2122-330
2122-333 2122-330
2122-311 2122-306
2122-311 2122-306
2122-311 2122-306
2122-311 2122-306
2122-311 2122-306
49