Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Disconnect the mains plug from the supply socket when not in use. To
avoid the risk of electric shock do not remove the cover of the apparatus.
There are no user serviceable parts inside. To prevent fire or shock
hazard do not expose the apparatus to rain or moisture.
CLOCK
1. Set the ON/OFF/AUTO switch (1) to 'OFF' connect the Main Cord to
the power supply. The clock display will flash on and off indicating a
power interruption and that the display time is incorrect.
2. To set the correct time, press the TIME SET button (6) and MINUTE
SET button (10), or HOUR SET button (9), together, until the correct
time is displayed.
3. Open the Clock Battery Compartment door and fit a 9V battery. The
purpose of this battery is to store the information relating to alarm time.
And to keep the clock functioning in the event of disconnection from
the mains supply or power interrruption. Should this occur. The clock
will continue to keep time, but will not display.
THE LED DIGITAL CLOCK AND THE PROJECTION
TIME SETTING FOR PROJECTION
- Switch the projection switch to the 'ON' position.
- To preset the HOURS, press simultaneously the HOUR BUTTON (21)
and the TIME BUTTON (20), keep them depressed until the hour digits
to be preset are displayed.
- To preset the MINUTES, press simultaneously the MINUTE BUTTON
(22) and the TIME BUTTON (20). Keep them depressed until the
minute digits to be preset are displayed.
- Focus setting : To adjust the projection clock definition by turning the
FOCUS (23) until the project's time is clearly shown on the ceiling or
wall.
NOTE : PROJECTS TIME IMAGE ON THE CEILING OR WALL OF A
DARKENED ROOM.
MAXIMUM PROJECTION DISTANCE IS 3-9 FEET.
CLOCK MUST BE SET SEPARATELY
Publicidad
