Kenwood DPX795BH Manual De Instrucciones página 14

HD Radio™ Tuner
Direct Access Tuning
(using the remote control)
1 Press DIRECT to enter Direct Access Tuning.
2 Press the number buttons to enter a station frequency or channel
number.
3 Press ENT IW to search for station or channel.
• To cancel, press or DIRECT.
• If no operation is done for 10 seconds after step 2, Direct Access Tuning is
automatically canceled.
Select an HD Radio multicast channel
Many HD Radio stations offer more than one channel programming. This
service is called multicasting.
While receiving HD Radio multicast channels....
Press S / T to select your desired channel (HD1 to HD8).
"LINKING" appears while linking to a multicast channel.
Receive an Emergency Alert message
You can receive an emergency alert message while listening to another
source or while in STANDBY, via HD Radio Broadcast.
Activate emergency alert message reception
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [TUNER SETTING], then press the knob.
3
Turn the volume knob to select [EA], then press the knob.
4
Turn the volume knob to select [ON], then press the knob.
5
Press and hold to exit.
• To deactivate emergency alert message reception, select [OFF] in step 4.
• To return to the previous setting item, press
8
ENGLISH
Receive an emergency alert message
When an emergency alert message is received, it appears and remains on
the display until the user performs the "Ignore" function.
Press B SRC (or press SRC on the remote control) to ignore the alert
message.
The same emergency alert message will not interrupt again for 12 hours.
Display received emergency alert messages
The received emergency alert messages are stored in the Alert Message List,
and you can check them later.
While listening to the HD RADIO source...
1
Press
2 Turn the volume knob to select a message.
3 Press the volume knob to display the information related to the
message.
4
Press
• "NO LIST" appears when the list is empty.
• This feature can store up to four messages in the list.
• To clear the message list, set [FACTORY RESET] to [YES]. (Page 7)
Other settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (page 9), then press the
knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4 Press and hold
.
To return to the previous setting item, press
to display the Alert Message List.
again to exit.
to exit.
.