Publicidad
Idiomas disponibles
Idiomas disponibles
Installation/Connection
Installing in Toyota cars
Install onto the car brackets using the supplied screws (E) or (F). Use the
mounting holes (
) or (
) that fit the car brackets. Then, install the
supplied trim plate (C).
Do the required wiring.
(Page 33)
Dashboard of your car
* Only for illustration purpose.
32
ENGLISH
Car bracket*
Installing the unit (without mounting sleeve)
1
Remove the mounting sleeve and trim plate from the unit before
installing.
2
Align the holes in the unit (on both sides) with the vehicle mounting
bracket and secure the unit with supplied screws.
Use only the specified screws. Using wrong screws might damage the
unit.
Removing the unit
1
Fit the catch pin on the extraction keys into the holes on both sides of
the trim plate, then pull it out.
2
Insert the extraction keys deeply into the slots on each side, then
follow the arrows as shown on the illustration.
Publicidad
