Publicidad
Agitator Assembly
Assemblage de l'agitateur
Agitator Support
Montaje del agitador
Support de brosse
Soporte del agitador
Cover
Couvercle
Cubierta
Replacing Belt
Motor Shaft
Arbre du moteur
Eje del transmissión
del motor
Base
Base
Base
Tab
Languette
Ranura
➢ ➢ Slide washers and agitator
supports onto brush agitator unit.
➢ ➢ Install new belt in belt groove on
the agitator assembly, then over the
motor shaft.
➢ ➢ Be sure belt is under belt guard.
➢ ➢ Insert both support tabs into the
base slots.
➢ ➢ Snap agitator supports into place.
➢ ➢ Line up front of cover and base.
➢ ➢ Rest cover on front edge of base as
shown.
➢ ➢ Tilt cover to back.
➢ ➢ Press cover firmly until tabs snap
into place.
➢ ➢ Replace cover screws, light bulb and
light cover.
- 38 -
Publicidad
