Descargar Imprimir esta página

Metabo MS 36-18 LTX BL 40 Manual Original página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 48
Do not expose battery packs to fire!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch or short circuit battery pack contacts!
A slightly acidic, flammable fluid may leak
from defective Li-Ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks out
and comes into contact with your eyes, wash them
with clean water and seek medical attention
immediately!
If the machine is defective, remove the battery pack
from the machine.
Transport of Li-Ion battery packs:
The shipping of Li-Ion battery packs is subject to
laws related to the carriage of hazardous goods (UN
3480 and UN 3481). Inform yourself of the currently
valid specifications when shipping Li-Ion battery
packs. If necessary, consult your freight forwarder.
Certified packaging is available from Metabo.
Only send the battery pack if the housing is intact
and no fluid is leaking. Remove the battery pack
from the machine for sending. Prevent the contacts
from short-circuiting (e.g. by protecting them with
adhesive tape).
Reducing dust exposure:
WARNING - Some dust created by power
sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
- Lead from lead-based paints,
- crystalline silica from bricks and cement and other
masonry products, and
- arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals,work in a well-
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic
particles.
This also applies to dust from other materials, such
as some timber types (like oak or beech dust),
metals, asbestos. Other known diseases are e.g.
allergic reactions, respiratory diseases. Do not let
dust enter the body.
Observe the relevant guidelines and national
regulations for your material, staff, application and
place of application (e.g. occupational health and
safety regulations, disposal).
Collect the particles generated at the source, avoid
deposits in the surrounding area.
Use suitable accessories for special work. In this
way, fewer particles enter the environment in an
uncontrolled manner.
Use a suitable extraction unit.
Reduce dust exposure with the following measures:
- do not direct the escaping particles and the
exhaust air stream towards yourself or nearby
persons or towards dust deposits,
- use an extraction unit and/or an air purifier,
- ensure good ventilation of the workplace and keep
it clean using a vacuum cleaner. Sweeping or
blowing stirs up dust.
- Vacuum or wash protective clothing. Do not blow,
beat or brush protective gear.
5. Overview
See page 2.
1 Chainsaw guard
2 Guide rail (saw rail)
3 Sealing cap (chain lubricating oil)
4 See-through oil tank
5 Pronged stop
6 Hand protection
7 Bow handle
8 Battery pack release button
9 Capacity indicator button *
10 Capacity and signal indicator *
11 Battery packs *
12 Safety switch (against unintentional starting)
Note: It is located outside the gripping area of
the hand and can be recognised by the raised
bit in the handle area)
13 Trigger
14 Trigger grip (gripping area)
15 Felling bar (for precise targeting)
16 Chain wheel cover
17 Nuts (captive)
18 Combination wrench
19 Lubrication hole
20 Chain wheel
21 Chain tensioning pin
22 Clamping screw (chain tension)
23 Stud bolt
24 Oil channel
25 Sawing chain
26 Guide rail slot
27 Bore
28 Guide rail oil inlet bore
* depending on equipment/not included in scope of
delivery
6. Initial Operation
6.1
Fitting guide rail and sawing chain,
setting chain tension
See illustration on page 2.
WARNING! Remove the battery packs (11) .
Unintentional start-up can cause serious
injuries. The motor must be stationary.
Wear protective gloves.
1. Loosen the captive nuts (17) and take off the
chain cover (16).
ENGLISH en
15

Publicidad

loading