Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Trouble Shooting
Trouble
The dryer
will not start
Hot surface
or burning
smell
• The clothes in machine are
• Not to take out the clothes
Clothes
too dry
• The clothes don't assort
• The temperature is
Clothes
shrink
• lt is right for synthetic
Hairball on
clothes
The sound of dryer when runs can cause
• Buzz or vibration: Due to heavy wet clothes' turning and
bumping, and this will cause noise accordingly.
• Air bumping: When drying, the machine will generate steam
which will come out from the pipe and this can cause bumping
with the bottom of inner tub.
Cause
• Power cut.
• The power plug is not
plugged light.
• Dry clothes exceed.
• The temperature fuse
is cut.
• The lint filler is dirty.
• The uptake or exhaust
duct is dirty.
too full.
in time when finish.
properly.
enacted too high.
• Too dry
fibre and permanent
press fibre causing
hairballs. This is because
the right rub causing.
• Wait for switching on
electricity.
• Check the power socket,
make sure plug light.
• The clothes in drier must be
after spining, and drying
clothes can not exceed 6kg.
• A technician should restore
the temperature fuse.
• Make sure clean the lint
filler in time.
• Clean out the stem.
• Make sure the clothes are
not too full.
• Take out the clothes
immediately when finish.
• See page 7.
• Observe the maintenance
label on clothes.
• Observe the maintenance
label on clothes, if easy to
shrink, should examine the
clothes when dry. Take out
the clothes when tiny damp
for too dry. Then hang the
clothes until full dry.
• Use fabric softener lubricate
fibre, please spray settled
gule on cuff and neckline
when iron clothes. Turn the
sarcenet out for reducing rub.
18
Solution
V.2
Publicidad
