Makita AC001G Manual De Instrucciones página 12

NOTICE:
Risk of Property Damage
Always drain water from the air tank. The water
may contain oil and rust which can cause stains.
NOTE: If drain valve is plugged, release all air pres-
s u r e . T h e v a l v e c a n t h e n b e r e m o v e d , c l e a n e d , t h e n
r e i n s t a l l e d .
NOTE: Compressed air generates condensate which
accumulates in the tank, filter, or other parts. The
c o n d e n s a t e c o n t a i n s l u b r i c a t i n g o i l a n d / o r s u b s t a n c e s
w h i c h m a y b e r e g u l a t e d . F o l l o w t h e r e g u l a t i o n s i n
your region when disposing of the condensate.
6. After the water has been drained, close the drain
valve. The air compressor can now be stored.
WARNING:
Drain Air Tank Properly. Improper
draining of the air tank can result in corrosion and
possible bursting of the tank. Tank bursting could
lead to personal injury and property damage.
MAINTENANCE
WARNING:
Never use the air compressor
which is operating abnormally.
If the air compressor appears to be operating
unusually, making strange noises or vibration,
stop using it immediately and arrange for repairs
by a Makita authorized service center.
WARNING:
Use only genuine Makita replace-
ment parts.
Replacement parts not manufactured by Makita
may void your warranty and can lead to malfunc-
tion and result in injuries. Genuine Makita parts
are available from an authorized dealer.
WARNING:
UNIT CYCLES AUTOMATICALLY
W HEN PO W ER IS ON. W HEN DOING
MAINTENANCE, YOU MAY BE E X POSED TO
VOLTAGE SOURCES, COMPRESSED AIR
OR MOVING PARTS. PERSONAL INJURIES
CAN OCCUR. BEFORE PERFORMING ANY
MAINTENANCE OR REPAIR, THE TOOL IS
S W ITCHED OFF AND THE BATTERY CARTRIDGE
IS REMOVED AND BLEED OFF ALL AIR
PRESSURE.
CAUTION:
Always be sure that the tool is
s itched o and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
To ensure efficient operation and longer life of the
air compressor unit, a routine maintenance sched-
ule should be prepared and followed. The following
procedure is geared to a unit in a normal working
environment operating on a daily basis. If necessary,
the schedule should be modified to suit the conditions
under which your compressor is used. The modifica-
tions will depend upon the hours of operation and the
working environment. Compressor units in an extremely
dirty and/or hostile environment will require a greater
frequency of all maintenance checks.
Maintenance routine
1. Drain water from the air tank, any moisture sepa-
rators or air filter regulators.
2. Check for any unusual noise and/or vibration.
3.
Inspect air filter, replace if necessary.
4.
Inspect air lines and fittings for leaks and correct
as necessary. Each year of operation or if a problem is
suspected, check condition of check valve. Replace if
d a m a g e d o r w o r n o u t .
5. Keep all screws, bolts, and covers tightly
mounted. Check their conditions periodically.
WARNING:
properly tightened. If screws plates or covers
become loose personal injury or property damage
may occur.
12 ENGLISH
Keep all screws, bolts and covers