Vestfrost VLS 064A RF AC Instrucciones Para El Uso página 6

GB
Electrical connection
This device complies with relevant EU
directives including Low Voltage Directive
2014/35/EU and Electromagnetic Compat-
ibility Directive 2014/30/EU
The socket should be freely accessible.
Connect the appliance only to 220-240V
50/60Hz mains supply via a correctly in-
stalled earthed socket.
The socket must be fused with a 10-13 A
fuse.
If the appliance is to be operated in a non-
European country, check on the rating plate
whether the indicated voltage and current
correspond to the values of your mains
supply.
Information regarding voltage, current or
power are given on the rating plate
Check that the plug fits your type of socket.
If it does not fit, procure an appliance cord
with the correct plug or have a qualified
electrician to fit the plug according to
country standards. This appliance must be
earthed.
Do not plug several appliances and the ref-
rigerator into the same multiple power strip.
The refrigerator should always be plugged
into its own individual electrical outlet which
has a voltage rating that matches the vol-
tage listed on the refrigerator's rating plate.
Ensure that the plug and socket matches
and that the appliance is earthed.
Voltage stabilizers
In order to protect the electrical compo-
nents, the appliance is equipped with an
internal voltage stabilizer for extended input
range, that will safeguard the equipment
against high/low mains voltage, high/low
spikes and surges protection in line with
WHO/PQS E007/VS01-VP.5
The internal extended stabilizer monitors
the mains voltage continuously. If the volta-
ge rises or drops, the stabilizer will stabilize
the output to ensure the voltage reaching
the appliance remains constant at 230V
(+/-2%), within the operating range of the
unit. If the input voltage falls below 110V or
rises above 285V, the stabilizer will discon-
nect the output, thereby protecting the load.
Once the mains voltage returns within ac-
ceptable limits, the stabilizer will reconnect
the output following a startup delay.
Delay in restoring supply:
When under or over-voltage cut-out has
occurred and the input voltage has retur-
ned to the operating range, the output is
automatically restored after the factory set
delay time delay (3-3:30 minutes random)
when the mains voltage again is within the
recommended range and stable.
6