Burley Nomad Manual De Instrucciones Y Seguridad Del Propietario página 7

Attaching the Wheels
1
Push in the rubber button on the
outside of the wheel hub.
Attaching the Trailer to Your Bicycle
1
Quick Release or Nutted Axle:
remove quick release skewer or axle
nut from left side of bike's rear-wheel.
Install the hitch between quick release
or axle nut and frame with the hitch tabs
parallel to ground. tighten quick release
or axle nut following bike manufacturer's
recommendation.
consult Burley.com for adapters
designed to help fit your trailer
to your bike if necessary.
Thru Axle:
requires adapted thru axle to install
hitch. consult Burley.com to obtain
proper fit and installation to your bike.
noMAd
2
Insert wheel axle into axle receiver,
and then release the button.
Pull firmly on wheel to confirm
the axle is fully engaged.
Hooking the tow bar to the hitch:
Insert flex connector in between
the two holes on the hitch. Insert
lock pin and close retainer.
the hitch can remain on the bike
when trailer is removed.
ENG DEU FRA ESP
Removing the Wheels
1
Push in the rubber button on the
outside of the wheel hub. Pull
wheel out of axle receiver.
2
note
ASSEMBLY & uSE
7