Publicidad
Idiomas disponibles
Idiomas disponibles
Manual WT 758
Setting in
Pull down the lid of the battery compartment (at the bottom of the case).
Insert a new battery (AA type, LR6, 1,5 V), observing correct polarity as indicated in the battery compartment. Put lid back again.
Setting the clock automatically
The clock starts automatically receiving the DCF signal and displays after 2 - 5 minutes the correct time. If the clock still has not set
itself after 10 minutes, reception is faulty or not possible at the chosen location. Interferences could be electronically devices like TV
or PC. The disturbance range can be a circuit of up to 2 meter. Press RESET button on the backside and repeat setting at a
different location.
Manual setting
Press and hold the M.SET button to manually set the time.
Restart
Press the RESET button to restart the clock.
Switch on alarm
Push the alarm ON/OFF button upwards. The alarm sounds at the set alarm time.
Interrupt alarm (snooze)
Press SNOOZE button on top of the alarm clock. The alarm is interrupted and the backlight is activated. The alarm sounds again
after 5 minutes.
Switch off alarm
To switch off the alarm, push the alarm ON/OFF – button down.
Backlight
To activate backlight, press SNOOZE button on top of the clock.
Hereby, Technotrade declares that this product WT758 is in compliance with the essential requirements and other relevant
provisiowns of Directive 2014/53/EU and ROHS 2011/65/EC. The original EU declaration of conformity may be found at:
www.technoline.de/doc/4029665007588
Environmental reception effects
The clock obtains the accurate time with wireless technology. Same as all wireless devices, the reception is maybe affected by the
following circumstances:
long transmitting distance
nearby mountains and valleys
near freeway, railway, airports, high voltage cable etc.
near construction site
among tall buildings
inside concrete buildings
near electrical appliances (computers, TV's, etc) and metallic structures
inside moving vehicles
Place the clock at a location with optimal signal, i.e. close to a window and away from metal surfaces or electrical appliances.
Precautions
This main unit is intended to be used only indoors.
Do not subject the unit to excessive force or shock.
Do not expose the unit to extreme temperatures, direct sunlight, dust or humidity.
Do not immerse in water.
Avoid contact with any corrosive materials.
Do not dispose this unit in a fire as it may explode.
Do not open the inner back case or tamper with any components of this unit.
Batteries safety warnings
Use only alkaline batteries, not rechargeable batteries.
Install batteries correctly by matching the polarities (+/-).
Always replace a complete set of batteries.
Never mix used and new batteries.
Remove exhausted batteries immediately.
Remove batteries when not in use.
Do not recharge and do not dispose of batteries in fire as the batteries may explode.
Ensure batteries are stored away from metal objects as contact may cause a short circuit.
Avoid exposing batteries to extreme temperature or humidity or direct sunlight.
Keep all batteries out of reach from children. They are a choking hazard.
Publicidad
