Descargar Imprimir esta página

SWR 350X Instrucciones De Funcionamiento página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

Note: Please take a moment to verify that the following items were included in your SWR 350x packaging:
AC Cable, SubWave Activator Footswitch, Footswitch Cable.
350X • FRONT PANEL FEATURES
• Dual independent input jacks compatible with both passive and active instruments
• Preamp Gain control with red LED clip indicator
• Aural Enhancer control
• SubWave™ Activator Switch (illuminated blue when engaged)
• SubWave™ Level control
• Bass control
• Midrange Level control
• Midrange Frequency control
• Treble control
• Effects Blend control (with pull-limiter-defeat option)
• Master Volume control
• Illuminated Neon Power On/Off switch
350X • REAR PANEL FEATURES
• XLR Pad (Level) control
• XLR Output jack
• XLR Mode switch (Direct, Direct + Sub, Line)
• Ground/Lift switch for XLR Output jack
• Tuner Out jack
• Side-Chain Effects Loop (Effects Send and Effects Return 1/4" jacks)
• SubWave™ Activator Footswitch jack
• Fan Mode switch
• Two Speakon and two 1/4" Speaker Output jacks
• Speaker Fuse (3AG, 10-amp fast-blo)
• Line Fuse
• AC Power Cord Receptacle
ELECTRICAL SPECIFICATIONS
Note: All measurements were taken with a line voltage of 120VAC. All noise specifications are "unweight-
ed." All voltages and watts are "RMS." All measurements are taken with tone controls set flat, Aural
Enhancer at minimum.
Power Ratings (minimum):
350 Watts @ 4 ohms
240 Watts @ 8 ohms
Frequency Response (power amplifier):
–3dB @ 20 Hz and 40 kHz
Sensitivity (full output under clipping, 8 ohms load, 100 Hz):
Passive Input Jack: 38 millivolts
Active Input Jack: 60 millivolts
Power Amplifier (Effects Return Jack "in"): 5 volts
350x • 7

Publicidad

loading