Publicidad
Idiomas disponibles
Idiomas disponibles
CONTENTS
Connecting water to the appliance
1. Remove the rubber plug (1) from the water
inlet valve.
2. Firmly push the water tube onto the water
inlet valve and tighten up the collar nut. This
water pipe needs to be cut from the middle
and used, and the other section is used as a
spare part.
Connecting to the water tap
This feature is only available on some models.
1. Push the water tube into the hole of the tap connector
supplied in the accessories. The pipe should be held
firmly whilst the connector is pushed onto the pipe.
2. Ensure that the rubber washer is fitted to the inside of
the tap connector before screwing it onto the tap.
► A separate connector or adaptor may need to be
purchased if your tap fitting does not match the thread
size of the connector provided.
Checking the Water Connection
This feature is only available on some models.
► Turn on the water supply and switch on the appliance. Carefully check all fittings for
possible leaks due to poorly fitted hoses.
► Press and hold the 3Sec. Filter Reset button for three seconds. The new water filter has
been activated.
► Place a cup under the water dispenser to verify that water is flowing through the
appliance.
► Check the connecting tube and joints for leaks once again.
Installation
39
Publicidad
