Descargar Imprimir esta página

Gastrodomus WM35DD Manual Del Usuario página 26

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Our equipment is not able to remove burnt residuals deposited on the dishes. Pre-treat the dishes
mechanically/chemically (for example, prewash under running water) before loading dishes with this type of soil.
The use of "foaming" /non specific detergents or detergents used not according to the manufacturer's instructions
could cause damage to the dishwasher and jeopardise the final result.
Failure to remove detergent residues, possibly used for a manual prewash, could cause the dishwasher to
malfunction and jeopardise the washing result
Change the water in the basin at least once a day.
Never leave coffee grounds on the dishes, as during the wash cycle they could pass through the filter and remain
in circulation for a long period of time as well as leave small unsightly black dots on the clean dishes
41.
END OF SERVICE AND DAILY CLEANING
Aprire Open the door and remove the basket with the clean dishes.
Remove the overflow pipe from the basin filter by pulling it upward as indicated by the arrow in the figure below
and let the basin empty from the water content.
Close the door and press the drain button
Wait a few minutes, when the Start light no longer flashes 6 times and then pauses
Turn off the dishwasher with the "on / off" button
WARNING !! (cleaning the outer surfaces)
Before starting with cleaning operations, disconnect the equipment's electric power supply located on the electric
panel, remembering that the machine remains powered when only the switch on the control panel is turned off.
Wash the stainless steel surfaces with warm soapy water, avoiding the use of detergents that contain abrasive
substances, scourers, brushers or steel scrapers, then rinse with a wet cloth and dry carefully.
Clean the control panel with a soft cloth moistened with water and, if necessary, neutral detergent. Do not wash the
equipment with direct or high pressure jets of water
The equipment must not be cleaned with water jets. In order to reduce the release of polluting substances to the
environment, it is recommended to clean the equipment with products that have a level of biodegradability above
90%.
Leave the door open for the entire period the machine will not be used.
pag. 25
WARNING!!
DOC. W010211 – REV.4

Publicidad

loading