Publicidad
Idiomas disponibles
Idiomas disponibles
LOCATING OPERATOR CONTROLS: The controls for the light system
must be located so that the VEHICLE and CONTROLS can be operated
safely under all driving conditions.
AIRBAG DEPLOYMENT: Do not install equipment or route wiring in
the deployment path of an airbag. Failure to observe this warning
will reduce the effectiveness of the airbag or potentially dislodge the
equipment, causing serious injury or death.
•
Decide where to route wiring around airbag areas.
•
Decide where to route the power and ground wires from the light bar.
SEAT REMOVAL PRECAUTION: If a vehicle seat is temporarily
removed, verify with the vehicle manufacturer if the seat needs to
be recalibrated for proper airbag deployment. Failure to follow this
warning may cause serious injury or death.
•
To make wiring easier, remove the seats and spare tire, and pull down
the headliner where needed.
•
Separate all electronic equipment wiring from two-way radio
equipment wiring.
INSTALLATION PRECAUTIONS: The warning system and/or two-way
radio system may operate improperly if a two-way radio antenna is
installed on or within 18 inches of the light bar. Before permanently
installing the light bar or a two-way radio antenna, test the warning
system and two-way radio system. Some installations may require the
relocation of the two-way radio antenna to the trunk or fender. DO NOT
drill holes in the light bar or install auxiliary devices on the light bar, or
the warning system may fail.
•
To avoid interference, keep two-way radio antennas a minimum of
18 inches (45.7 cm) away from warning equipment.
•
Whenever possible, run full wire lengths. DO NOT splice the wires.
Installation, Operation, and Maintenance Instructions
Federal Signal www.fedsig.com
Preparing for the Light Bar Installation
11
Publicidad
