Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Message to Installers of Warning Light Equipment
•
If a vehicle seat is temporarily removed, verify with the vehicle
manufacturer if the seat needs to be recalibrated for proper airbag
deployment.
•
Before mounting any components, check the manual to ensure that
the component you are installing is suitable for use in that area of
the vehicle. Many components are not suitable for use in the engine
compartment or other extreme environmental exposure areas.
•
When drilling into a vehicle structure, ensure that both sides of the
surface are clear of anything that could be damaged. Remove all burrs
from drilled holes. To prevent electrical shorts, grommet all drilled
holes through which wiring passes. Ensure that the mounting screws
do not cause electrical or mechanical damage to the vehicle.
•
Refer to the instruction sheet packed with the lighting system for
proper electrical connections, additional precautions, and information.
•
Because vehicle roof construction and driving conditions vary, do not
drive a vehicle with a magnetically mounted warning light installed.
The light could fly off the vehicle, causing injury or damage. Repair of
damage incurred because of ignoring this warning shall be the sole
responsibility of the user.
•
Locate the light system controls so the VEHICLE and CONTROLS can
be operated safely under all driving conditions.
After Installation or Service
•
After installation, test the light system to ensure that it is operating
properly.
•
If a seat is temporarily removed, verify with the vehicle manufacturer if
the seat needs to be recalibrated for proper airbag deployment.
•
Test all vehicle functions, including horn operation, vehicle safety
functions, and vehicle light systems, to ensure proper operation.
Ensure that the installation has not affected the vehicle operation or
changed any vehicle safety function or circuit.
•
Scratched or dull reflectors, mirrors, or lenses will reduce the
effectiveness of the lighting system. Avoid heavy pressure and use
of caustic or petroleum-based products when cleaning the lighting
system. Replace any optical components that may have been
scratched or crazed during system installation.
6
Federal Signal www.fedsig.com
HighLighter
Elite
®
Publicidad
