Federal Signal Corporation HighLighter Elite Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 13

accessory plug socket. Turn the plug on and off using the power switch
on the plug. To show that the power is on, a pilot light turns on.
4. To remove models with suction cups, pull up on the release tabs while
picking up the light bar.
Permanently Mounting the HighLighter Elite
Use the supplied permanent mounting bracket to mount the light to a flat
surface or a flat bar using installer-supplied hardware.
Attaching the Light to a Flat Surface
To permanently mount the HighLighter Elite to a flat surface:
1. Attach the bracket to the bottom of the light using supplied hi-low
screws. See Figure 1.
2. Using the bracket as a template, scribe the four (4) mounting hole
locations.
Installation, Operation, and Maintenance Instructions
Federal Signal www.fedsig.com
Permanently Mounting the HighLighter Elite
Figure 1 Flat Surface Mount
#10 Hi-Low Screw
Bracket
Light
13