Publicidad
Idiomas disponibles
Idiomas disponibles
Magnetic or Suction Cup Magnet Mounting
•
Do not coil excess wire. Leave a drain loop for servicing the light bar.
•
After drilling holes for wires, deburr them, smooth sharp edges, and
insert grommets to protect the wires from chafing.
•
When you frame-ground the equipment, use the manufacturer-
supplied ground locations in the vehicle.
IMPORTANT: After the installation, frequently inspect the light bar and
mounting feet to ensure that all fasteners and brackets are tight.
Magnetic or Suction Cup Magnet Mounting
DO NOT DRIVE WITH MAGNETICALLY-MOUNTED WARNING LIGHT
INSTALLED: Because vehicle roof construction and driving conditions
vary, do not drive a vehicle with a magnetically mounted warning light
installed. The light could fly off the vehicle, causing injury or damage.
Repair of damage incurred because of ignoring this warning shall be
the sole responsibility of the user.
PROPER MAGNETIC MOUNTING: The holding power of magnetic
mounting systems is dependent upon surface finish, surface flatness,
and thickness of the steel mounting surface. Therefore, to promote
proper magnetic mounting:
•
Keep the mounting surface and magnets clean, dry, and free of
foreign particles that prevent good surface contact.
•
Ensure that the mounting surface is flat.
•
Do not use a magnetic mounting system on vehicles with vinyl
tops.
To mount the HighLighter Elite:
1.
Place the light bar assembly on the vehicle roof at a location that
provides maximum signaling effectiveness for your application.
2. For models with suction cups, release trapped air by applying
downward pressure to the top of the dome while pulling up on the
release tabs.
3. To operate the magnet-mounted or suction cup magnet light bar
assembly, insert the plug at the end of the cable assembly in the
12
Federal Signal www.fedsig.com
HighLighter
Elite
®
Publicidad
