Federal Signal Corporation HighLighter Elite Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 21

Configuring the HighLighter Elite
Alternatively, Dim Mode can be activated on Mode 1 or 2 by setting Mode
3 to pattern 26 (Dim Mode) and simultaneously powering Mode 3 with
either Mode 1 or Mode 2.
NOTE: When pattern 10 (steady) is selected, the Dim Mode function will
cycle through three settings: normal, dim, and cruise.
Resetting the Device to the Default Settings
To reset the device to the default settings, apply power to the green wire
while Mode 1, Mode 2, or Mode 3 is powered. Hold the wire to the power
source until the light pulses seven times, and then remove power.
NOTE: No change occurs if you remove power from the green wire after
the seventh pulse finishes.
Installation, Operation, and Maintenance Instructions
21
Federal Signal www.fedsig.com