Dreame Bot W10 Manual Del Usuario página 16

How to Use
EN
Fast Mapping
Do not attach the mop pad. Place the robot on the base, and the robot turns
on automatically.
The first time you use the robot, build a map as instructed on the app. Then,
the robot moves around to scan the environment and builds a map without
cleaning. After the robot returns to the base, a map is built and saved
automatically.
Turn On/Off
Press and hold the button for 3 seconds to turn on the robot. Once the
power indicator is permanently on, the robot is on standby. To turn off the
robot, press and hold the
moving.
Start Cleaning
Press briefly the and buttons on the base, and the robot starts cleaning.
Note:
· Make sure that the robot is fully charged before using it. Do not manually move
the robot when it is cleaning.
· If the battery gets low while cleaning, the robot returns to the base and resumes
cleaning after charging its battery. The Resume Cleaning function must be
enabled on the app in advance.
12
button for 3 seconds when the robot is not
Cleaning Mode
After the robot is turned on, it cleans each room by cleaning along the
edges and walls first and then cleaning in an S-shaped pattern. The robot
automatically returns to the base to charge its battery after cleaning.
Pause/Sleep
When the robot is cleaning, press briefly any buttons on the robot or the
button on the base to pause the robot.
If the robot pauses for more than 10 minutes, it automatically enters the sleep
mode, and the power indicator and charging indicator stop glowing. Press
any buttons on the robot or base, or tap on the app to wake up the robot.
Note:
· The robot will turn off automatically if it is left in the sleep mode for more than 12
hours.
· If the robot is paused and placed onto the base, the current cleaning process will
end.
Spot Cleaning
When the robot is paused or on standby, press and hold the
seconds to enable the spot cleaning mode. In this mode, the robot cleans a
square-shaped area of 1.5 × 1.5 meters around it and returns to its starting
point once the spot cleaning is completed.
Additional App Functions
A map must be built before using the preceding functions.
Follow the instructions on the app to use more functions.
The app software is upgrading, and the actual app user interface may be
different from the statements in this manual. Please follow the instructions
based on the current app version.
button for 3