Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
SAFETY SYMBOLS
This is the safety alert symbol. When you see this symbol on
your pump or in this manual, look for one of the following signal
words and be alert to the potential for personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause minor
personal injury or property damage if ignored.
The word NOTE indicates special instructions that are important
but not related to hazards.
CALIFORNIA PROPOSITION 65 WARNING
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.
GENERAL SAFETY
1.
Carefully read and follow all safety instructions in this
manual and on the unit itself.
2.
Follow all applicable local and state codes and regulations.
3.
RISK OF EXPLOSION. Do not ground to a gas
supply line.
Use high pressure reinforced type discharge hose
ONLY. See parts list for available hose, nozzle and
fittings. A high pressure relief valve is recommended.
DO NOT use garden hose with High Pressure Booster
pump. Garden hose will not stand the discharge
pressure produced and will fail.
High pressure discharge stream is dangerous. To avoid
injury, DO NOT aim the discharge stream at any person
or animal.
BE SURE that the pump suction pipe pressure plus
the pump discharge pressure does not exceed the
pressure rating of hose and fittings. See Table I for
pump discharge pressure ratings.
4.
RISK OF FIRE AND EXPLOSION. Can cause
severe injury, property damage or death. To avoid risk of
fire and explosion, pump water only with this pump. Do
not pump flammable liquids or chemicals. Do not use the
pump near gas pilot lights or where chemical or gas fumes
are present. Use of an electric pump with liquids other
than water or in an atmosphere containing chemical or gas
fumes may ignite those liquids or gases and cause injury or
death due to an explosion and/or fire.
FP327 (01-15-23)
5.
RISK OF BURNS. Never run the pump dry. To
do so can damage internal parts, overheat pump (which can
cause burns to people handling or servicing pump), and will
void warranty.
If water is trapped in the pump during operation it may
turn to steam. Trapped steam can lead to an explosion
and burns. Never run the pump with the outlet closed
or obstructed.
Do not touch an operating motor. Modern motors can
operate at high temperatures. To avoid burns when
servicing the pump, allow it to cool for 20 minutes after
shut-down before handling.
ELECTRICAL SAFETY
RISK OF ELECTRIC SHOCK . Can shock, burn or
kill. Ground the pump before connecting to a power supply.
Disconnect the power before working on the pump, motor or
tank.
The pump is non-submersible. Keep the motor dry at all
times. Do not wash the motor. Do not immerse. Protect the
motor from wet weather.
Disconnect the power to the pump before servicing the
pump. After the power is disconnected, let the pump cool
for 20 minutes before attempting to work on it.
Take extreme care when changing fuses. To reduce the
chance of fatal electrical shock, DO NOT stand in water or
put your finger in the fuse socket.
Ground the electrical outlet box.
3
Publicidad
