Stanley Fatmax FMXCMD152WE Manual De Instrucciones página 23

– Unwinding the hose: carefully remove the hose
from the housing; after unwinding the necessary
length of hose, loosen the grip slightly, in this way,
when a "CLICK" is heard, the lock is inserted (fig. 9).
Ensure that the hose is locked before releasing
the grip.
– Rewinding the hose: loosen the lock by pulling
the extension hose outwards (fig. 10). Let the hose
rewind in a controlled way, accompanying it until it
completely returns to the reel.
● Insert the power cord plug into a suitable socket, mak-
ing sure that the I/O switch on the compressor is in the
switched off position "O" (OFF).
● At this point the compressor is ready for use.
● Use the I/O switch to start the compressor pumping air
and putting it through the delivery hose into the tank.
● Once the upper calibration value has been reached
(set by the manufacturer during the test phase) the
compressor stops.
Using air, the compressor restarts automatically when the
lower calibration value is reached (2 bar between upper
and lower value).
● The compressor continues to operate with this cycle
automatically until acting on the I/O switch.
● If the compressor shall be used again, wait at least 10
seconds from the moment when it switches off before
restarting it.
● Check that the air consumption and the maximum
operating pressure of the pneumatic tool to be used
are compatible with the pressure set on the pressure
regulator (not included) and with the amount of air
delivered by the compressor.
● At the end of the work:
– rewind the hose completely, putting it in its housing;
– stop the compressor by acting on the I/O switch,
putting it to the switched off position "O" (OFF).
– disconnect the electrical plug;
– empty the tank.
FUNCTION
Cleaning of intake filter and/or
substitution of filtering element
Draining tank condensate
8. CLEANING AND MAINTENANCE
Pull the power plug before doing any cleaning and
maintenance work on the appliance.
Wait until the compressor has completely cooled
down. Risk of burns!
Always depressurize the tank before carrying out any
cleaning and maintenance work.
8.1 Cleaning
● Keep the safety devices free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow
it with compressed air at low pressure.
● We recommend that you clean the appliance immediately
after you use it.
● Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance. Ensure
that no water can get into the interior of the appliance.
● You must disconnect any pneumatic tools from the
compressor before cleaning. Do not clean the compressor
with water, solvents or the like.
● Keep the reel hose clean to allow proper sliding.
8.2 Condensation water (Fig. 11)
The condensation water must be drained off each day
by opening the drain valve (ref. 3) (on the bottom of the
pressure vessel).
Dispose of the condensation water in an environmentally
compatible manner at the appropriate collection point.
8.3 Safety valve (ref. 10)
The safety valve has been set for the highest permitted
pressure of the pressure vessel.
It is prohibited to adjust the safety valve. Actuate the
safety valve from time to time to ensure that it works when
required. Turn the nut until you can hear the compressed
air being released (Fig. 12). Then screw it back on.
Always keep the safety valve and the surrounding area
clean and free of obstructions.
Always keep the safety valve and the surrounding area
clean and free of obstructions.
MAINTENANCE RESUMPTIVE TABLE
AFTER THE FIRST
100 HOURS
●
Daily and at the end of work
23
Warning!
Warning!
Warning!
Warning!
EVERY 100 HOURS
●
G
B