Brink 3394 Instrucciones De Montaje página 4

GB
Couplings class
Approval number
D- Value
Max. trailers dimensions
Max. vertical load
FITTING INSTRUCTIONS: SKODA OCTAVIA
1. Remove the plastic sill and side lining.
2. Remove the bumper. Cut out in the lower part of the bumper as shown
in the template.
3. Remove bumperbeam and its fastenings-Do not mount it back again!
4. Fit the ends loosely to the frame-members on the car. See illustration!
5. Fit cross-beam loosely to the ends. See illustration!
6. Tighten all bolts with a torque wrench.
7. Fit electricity.
8. Fit the bumper, plastic sill and side lining.
9. Fit the ball and electrial socketplate as shown in the illustration.
10.Tighten all bolts with a torque wrench.
: A 50-X
: e11 00-2669
: 8.4 kN
: 1500 kg
: 60 kg
NOTE:
* Remove the insulating material from the contact area of the fitting points.
* All bolts are quality 8.8 - nuts 8. or when mentioned in fitting instructions
10.9 / 10.
* Don't forget the spring- and plain washers.
* Consult your dealer for the maximum tolerated pull weight and ball
hitch pressure of your vehicle.
* It is recommendable to retighten all fixing bolts and nuts after the towbar
has been in use for some 1000 km/600 miles.
* Do not drill through brake-or fuellines.
* Remove (if present) the plastic caps from the spot welding nuts.
Torque settings for nuts and bolts (8.8):
M10 46 Nm 41 Nm (with self-locking nut)
M12 71 Nm (with self-locking nut)
M14 125 Nm 113 Nm (with self-locking nut)
© 339470/07-07-2000/3