Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Cut the pipe into two pieces with the
required length to connect the filter (A) with
the appliance (B1) and the water tap (B2)
(Fig.10.5-1). Make sure to get a square cut
by using a sharp knife.
2.
Insert pipe (B1) approx.12 mm deep into
EN
the mounting fixture of the water fiter (A)
(Fig.10.5-2). Take care to install the fiter in
the correct direction. The dart shows the
direction of water flow.
3.
Secure the pipe with a locking clip (C)
according to Fig.10.5-3.
4.
Repeat step 2 and 3 with the pipe (B2) on
the other side of the fiiter
5.
Connect the end of pipe (B2) to one of
the adapters "D" or "E and F" which suits to
the water main (Fig.10.5-4).
6.
Remove the plug in the v alve at the back
of appliance) Fig.10.5-5).
7.
Connect the end of B1 to the valve at
the back of the appliance(Fig.10.5-6).
8.
Open the water tab to check if the
system is leak free and flush the pipe.
24
Equipment
Publicidad
