Functional Description - Makita SA9031 Manual De Instrucciones

switch is turned on.
10. Watch out for flying sparks. Hold the tool so
that sparks fly away from you and other
persons or flammable materials.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
13. Ventilate your work area adequately when you
perform sanding operations.
14. ALWAYS wear proper apparel including long
sleeve shirts, leather gloves and shop aprons
to protect skin
grindings.
15. Use of this tool to grind or sand some
products, paints and wood could expose user
to dust containing hazardous substances. Use
appropriate respiratory protection.
IF USED AS A GRINDER
16. Always use proper guard with grinding wheel.
A guard protects operator from broken wheel
fragments.
17. When using depressed center grinding wheels,
be sure to use only fiberglass-reinforced
wheels.
18. Check the wheel carefully for cracks or
damage before operation. Replace cracked or
damaged wheel immediately. Run the tool
(with guard) at no load for about a minute,
holding tool away from others. If wheel is
flawed, it will likely separate during this test.
19. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced wheel.
20. Use the specified surface of the wheel to
perform the grinding.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
from contact with
Symbols
The followings show the symbols used for tool.
･
･
･
･
･
hot
･
･
･

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Shaft lock
CAUTION:
Never actuate the shaft lock when the spindle is
•
moving. The tool may be damaged.
1
011641
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch handle mounting positions
3
011642
4
volts
amperes
hertz
alternating current
alternating or direct current
no load speed
Class II Construction
revolutions or reciprocation per minute
1. Shaft lock
1. Motor housing
1
2. Lock button
2
3. Handle
USD292-2