YATO YT-82760 Manual De Instrucciones página 14

GB
Screwing - unscrewing
Insert the right bit to tool's chuck. Select the direction of rotation using the switch. Then put the bit into the screw socket and press
the switch. Tool runs as long as the switch is being pressed.
Drilling
Due to the fact that the torque is too low, the product is not designed for drilling.
Additional notes
Do not exert too much pressure on the processed material during operation and do not make any sudden movements to prevent
damage to the work tool and screwdriver. Make regular breaks during the work.
Do not overload the tool, temperature of the outside surfaces can never exceed 60 °C.
After the work is complete switch off the screwdriver and perform maintenance and inspection operations.
Declared total value of vibration was measured by means of standardized test method and can be used to compare one tool with
the other. Declared total value of vibration can be used in the initial exposure assessment.
Warning! Emission of vibration when working with the tool may vary from the declared value, depending on how the tool is used.
Warning! It is required to determine safety measures to protect the operator, which are based on the exposure assessment in
real conditions of use (including all elements of work cycle, such as for example time when tool is switched off or idling and time
of activation).
MAINTENANCE AND OVERHAUL
ATTENTION! Before any adjustment, technical service or maintenance operations unplug the tool. Once the operations have been
finished, the technical conditions of the tool must be assessed by means of external evaluation and inspection of the following
elements: body and handle, conductor with a plug and deflection, functioning of the electric switch, patency of ventilation slots,
sparking of brushes, noise level of functioning of bearings and gears, start-up and smoothness of operation. During the guarantee
period, the user cannot dismantle the electric tools or change any sub-assemblies or elements, since it will cancel any guarantee
rights. All irregularities detected at overhaul or during functioning of the tools are a signal to have the tool repaired at a service
shop. Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protections must be
cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth without any chemical substances or
cleaning liquids. Tools and handles must be cleansed with a clean cloth.
O R I G I N A L I N S T R U C T I O N S
14