Disposal And Recycling - EINHELL TH-PL 900 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Anleitung_TH_PL_900_SPK8__ 11.09.12 15:13 Seite 20
GB
Check the correct setting (Fig. 13)
(8) Front base plate (moving plane shoe)
(5) Rear base plate (fixed plane shoe)
1. Correct adjustment
Result: Smooth planed surfaces
2. Notches in the surface
Problem: The cutting edge on the planing knife (or
both planing knives) is not parallel to the height of
the rear base plate.
3. Furrows at the start of the planed surface
Problem: The cutting edge on the planing knife (or
both planing knives) is below the height of the rear
base plate.
4. Furrows at the end of the planed surface
Problem: The cutting edge on the planing knife (or
both planing knives) is above the height of the rear
base plate.
8.4 Replacing the drive belt (Fig. 14-15)
The belt should be replaced by a trained expert.
n
The drive belt (b) must be replaced if it is worn.
n
Undo the screws (a) and remove belt cover at
n
the sides (6).
Remove the worn belt drive (b) and clean the two
n
belt pulleys (c/d).
Place the new drive belt on the small belt pulley
n
(c) and pull the belt onto the large belt pulley (d)
whilst turning the planing shaft.
Ensure that the longitudinal grooves on the drive
n
belt are in the guide grooves on the drive wheels.
Fit the belt cover (6) and secure it with the
n
screws (a).
8.5 Maintenance
There are no parts inside the equipment which
require additional maintenance.

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
20
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

Publicidad

Tabla de contenido
loading

Tabla de contenido