Worx WX543 Manual Original página 12

WORKING HINTS FOR YOUR
JIGSAW
If your power tool becomes too hot, please run your
jigsaw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Always use a blade suited to the material and
material thickness to be cut. For tight curves it is best
to use a narrow saw blade. When sawing metal or
similar materials, apply coolant/lubricant alongside
the cutting line.
Always ensure the workpiece is firmly held or
clamped to prevent movement. Any movement of
the material may affect the quality of the cut. The
blade cuts on the upward stroke and may chip the
uppermost. Ensure your uppermost surface is a non-
visible surface when your work is finished.
For easier control, use low speed to start cutting and
then increase to correct speed.
In order to avoid operation malfunctions, do not saw
gypsum board from below or overhead.
The guide roller should occasionally be checked for
wear and lubricated with a drop of oil. If it is worn, it
must be replaced.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
12
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0℃-45℃.
The recommended ambient temperature range for
the charging system during charging is 0℃-40℃.
Cordless Jigsaw
TROUBLESHOOTING
Possible
Symptom
Causes
Overload
Battery
temperature
The tool
too high
suddenly
stops
during
operation.
Low battery
capacity
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling
advice.
Possible Solution
Relieve the load
on the machine
immediately and
allow cooling for
approx. 30 seconds
by running the
machine on no-load.
Charge the battery
pack.
EN