GreenWorks GD40BC Manual Del Operario página 10

NOTE
Remove the remaining cutting line on the spool.
NOTE
Use only with the nylon cutting line of 2 mm diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into
the slot in the center rim of the spool. Make sure
that the line snaps into position in the slot.
3. With your finger between the lines, wind the lines
equally and tightly around the spool in the indicated
direction.
4. Put the lines in the line slots.
5. Do not wind the lines beyond the edge of the spool.
5.5 REMOVE THE TRIMMER HEAD
Figure 20.
1. Put the trimmer head tool in the specified angle
transmission hole to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
5.6 ASSEMBLE THE TRIMMER HEAD
Figure 20.
1. Put the trimmer head tool in the specified angle
transmission hole to fix the trimmer head.
2. Assemble the trimmer head.
3. Turn the trimmer head counterclockwise to tighten it.
4. Remove the trimmer head tool.
IMPORTANT
You must install the cut-off blade when you use the
trimmer head.
5.7 ASSEMBLE THE BRUSH CUTTER
Figure 21-22.
WARNING
Wear gloves and be careful with sharp edges.
WARNING
Apply the guard to the cutting blade.
WARNING
Use the specified nut which is packed with the cutting
blade, to assemble the cutting blade.
1. Put the trimmer head tool in the specified angle
transmission hole to fix the trimmer head.
English
2. Put the inner cup onto the center shaft.
3. Put the cutting blade on top of the inner cup. Make
sure the cutting blade is in the center.
4. Put the plate above the cutting blade.
5. Put the outer cup above the plate.
6. Put the nut above the outer cup.
7. Tighten the nut counter-clockwise with the wrench.
5.8 REMOVE THE BRUSH CUTTER
Figure 21-22.
Apply the guard to the cutting blade.
1. Put the trimmer head tool in the specified angle
transmission hole to fix the trimmer head.
2. Loosen the nut clockwise and remove the outer cup.
3. Remove the plate and cutting blade.
4. Remove the inner cup.
6 TRANSPORTATION AND
STORAGE
6.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack.
• Assemble the blade guard.
6.2 STORE THE MACHINE
• Remove the battery pack from the machine and
charge it.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
7
WARNING
EN