Publicidad
Idiomas disponibles
Idiomas disponibles
** If the answering machine is turned off and the master PIN is still set
at its default 0000, the answering machine will not answer to any in-
coming ringing, but if the master PIN has been changed, it will answer
after 10 rings to allow remote access.
The outgoing message
The model is supplied with two predefined outgoing messages (OGM)
used for the different answer modes.
There are 2 answer modes available: Answer Only and Answer & Record.
By default, the answer mode is ANSW.&RECORD, which allows a
caller to leave a message on the answering machine. This can be
changed to ANSWER ONLY mode, which does not allow callers to
leave any messages on the answering machine.
Set the answer mode
1. Press the MENU key to enter menu selection.
2. Press the Navigation key to select ANSW MACHINE and then press
OK key to select.
3. Press the Navigation key to select ANSWER MODE and then press
OK key to select.
4. Press the Navigation key to select ANSWER ONLY or
ANSW.&RECORD and then press OK key to confirm.
record a personalised outgoing message
* You can choose to replace the predefined OGM with your own pre-
recorded personalised messages.
1. Press the MENU key to enter menu selection.
2. Press the Navigation key to select ANSW MACHINE and then press
OK key to select.
3. Press the Navigation key to select RECORD OGM and then press
OK key to select.
4. Press the Navigation key to select ANSWER ONLY or
ANSW.&RECORD and then press OK key to confirm.
5. Press the Navigation key to select RECORD OGM.
6. Press OK key to start recording your new outgoing message.
7. Press OK key again to end the recording.
* The maximum length of an outgoing message is 2 minutes.
* To hear your outgoing message, select PLAY at step 5.
* To delete a personalised outgoing message and return to the pre-
defined one,
select DELETE at step 5.
Pg. 17
Publicidad
