Descargar Imprimir esta página

Panacom PA-7851 Manual Del Usuario página 28

Publicidad

Idiomas disponibles

Idiomas disponibles

Remote access – Deactivate
Base speaker – Level 5
TroUBLeShooTing
ALWAYS check first that: You have followed all the steps listed in
the user manual to install and set up your telephone. All connectors
are firmly inserted in their sockets. Mains power to the base unit is
switched on at the socket. The handset's batteries are correctly and
securely installed and are not run down.
everyDay USe
"i cannot make or answer calls"
If the handset's display is blank, it may have been switched off. Press
and hold the HANG-UP/ EXIT key to switch it back on.
Check that the base unit's mains power adapter is plugged in and
power is switched on. The base unit needs mains power for normal
operation of the phone– not just for charging the batteries.
Make sure you are using the telephone line
cable supplied with your PA-7831. Other telephone line cables might
not work. Move the handset closer to the base unit. Check the battery
level symbol on the display. If it is low, replace the handset on the base
unit or charger pod to recharge the batteries. Switch off power at the
mains socket, wait for a short time and then switch back on. This may
solve the problem.
"i cannot make a call"
If the handset display shows KEYS LOCKED, press and hold the * but-
ton to unlock it before you make a call. Only one handset (or the base
unit) can be connected to the outside line at a time. If another handset
is already using the line, you need to wait until it has finished its call.
"when i press on the keys, nothing happens"
Make sure the batteries are fitted in your handset. If the Battery Level
symbol on the display shows 'low', put your handset back on
the cradle to charge.
"when i key in a number, it appears on the display, but i cannot
make an outside call"
Try a different position for the base unit – somewhere higher if pos-
sible, or further from other electrical equipment. Try moving the hand-
set closer to the base unit.
"The phone does not ring"
Check that the base unit's mains power adapter is plugged in and
Pg. 28

Publicidad

loading