Publicidad
Idiomas disponibles
Idiomas disponibles
* If the remote access code is correct, a confirmation beep can be
heard, and then you need to press the 2 key, within 8 seconds, to start
playing any messages.
The remote feature lets you perform the following functions:
To
Review message
Play back messages
Stop message playback
Erase message
Skip message
Turn on answerer machine
Turn off answerer machine
* If the answering machine is off, and the master PIN has been changed
from its default 0000, it will answer the call after 10 rings. Dial the mas-
ter PIN code within 8 seconds and you will hear a beep to confirm you
have entered the remote access mode, as above.
Set the OGM voice language (optional)
1. Press the MENU key to enter menu selection.
2. Press the Navigation key to select ANSW MACHINE and then press
OK key to select.
3. Press the Navigation key to select SETTINGS and then press OK
key to select.
4. Press the Navigation key to select LANGUAGE and then press OK
key to select.
5. Press the Navigation key to select your preferred language and then
press OK key to confirm.
6. A confirmation beep is played. Press HANG-UP/EXIT key to go
back to idle mode.
call screening
Call screening allows you to hear the caller while he is leaving a mes-
sage. You can then decide if you want to talk to the caller directly.
To adjust the speaker's volume during call screening, press + and - keys
on the base station. The lowest volume level turns call screening off.
Default settings
These are the answering machine settings after the unit has been reset.
Answering Machine - ON
Answer mode – ANSW.&RECORD mode
Number of rings before answer – 5
Outgoing messages – Predefined OGM. (Personalised OGMs deleted)
Press this button
1
2
8
6 (during message playback)
3
7
9
Pg. 27
Publicidad
