EHEIM compactON 5000 Manual De Instrucciones página 17

English
‧ Before use, carry out a visual inspection to ensure that the appliance, especially the mains cable and plug, are undam-
aged.
‧ Repairs must only be carried out by an EHEIM service centre.
‧ The mains cable of this appliance cannot be replaced. If the cable is damaged, the appliance must be scrapped.
‧ Only carry out the work described in these instructions.
‧ Only use original spare parts and accessories for the appliance.
‧ The appliance should be protected by a residual current protection device with a maximum rated residual current of 30
mA. Please contact an electrician if there are any questions or problems.
‧ In the event of water leakage or when the residual current protection device is triggered, immediately disconnect all
devices in the aquarium from the power supply.
‧ If they are not being used, always disconnect all devices in the aquarium from the power supply before you install/
remove any parts and before all cleaning and maintenance work.
‧ Protect the mains socket and mains plug against moisture and wetness. A drip loop must be
formed with the mains cable. This prevents any water running along the cable to the mains
socket, which would result in a short-circuit.
‧ The electrical data of the appliance must match the data of the power mains. This data is found
on the type plate, the packaging and in these instructions.
‧ The appliance has a magnet with a strong magnetic field that can affect pacemakers or
implanted defibrillators (ICD). Maintain a distance of at least 30 cm between the implant and
magnet.
Commissioning
Connecting the hose
1. Use a saw to shorten the connecting piece to the diameter of your hose (⌦A/B).
2. Screw the connecting piece onto the pump.
3. Connect your hose to the connecting piece.
‧ We recommend fastening the hose with a hose clamp.
Attaching the mounting plate
1. Screw the suction devices into the openings of the mounting plate (⌦C).
2. Move the mounting plate until it locks into the guides on the underside of the motor body (⌦D).
In order to remove the mounting plate, the release lever ① must be pressed.
17
Drip Loop