A DECE OASIS A20F Beast Manual De Instrucciones página 13

Electric bicycle fault inspection
and troubleshooting methods
Serial Number Fault description
Speed regulation failure
1
or speed less than 10 m/h
ub motor does not wor
2
after power on
Insu cient mileage
3
after charging
Charger not charging
4
The battery has su cient
power but no voltage
5
indicates that the electric
wheel hub is di cult to
After opening electric door
lock, it is found that the
6
signal part is normal and
the driving part is abnormal.
Abnormal ero start mode
switch left and right dis
7
Non- ero startup mode
e ception switch in
8
the middle
Note: hen a fault that cannot be eliminated by yourself or a fault that cannot be determined, the internal
damage of the motor, controller, charger, battery pac , etc. please send the vehicle to the place of
purchase or the company s special maintenance station for inspection and maintenance. During the
warranty period, please do not open important parts without authori ation, otherwise the company will
not guarantee.
1. hen doing bicycle maintenance, the battery must be removed to avoid abnormality that may cause re
or damage to the battery.
2. riginal parts should be used in repairing or maintaining the bicycle, otherwise your bicycle may not
wor properly, or related parts may be damaged.
Failure cause analysis Troubleshooting methods
1, ow battery voltage
2,Speeder failure
3,Transmission roup failure
1, oose battery wiring
2,Motor wiring plug loose o
3,Speeder failure
1,Insu cient tire pressure
2,Insu cient charging or
charger failure
3,Battery aging or damage
4,There are many uphill strong
headwinds heavy load poor
road Mow temperature
1,The plug is not inserted
properly
2,Charger fuse blown
3,Battery pac fuse blown
1, When starting the electric hub.
the voltage is lower than 30
2, Battery switching line fall o
3, Monitor connector loose
4, Controller failure
1, Battery under voltage;
2, Left and right brake handle
damage
3, The controller or motor is
damaged
4, Abnormal line
5, Motorcycle handlebar damage
or line di erence
1, The startup mode switch or
motorcycle handlebar is
damaged.
2, Abnormal line
1, Incorrect start-up ta switch
overlap or booster damage
2, Abnormal line
1, Fully charge the battery
2. end to maintenance station
for repair
1, Ta e out the battery bo and
hang it up.
2,Fastening wiring plug
3, end to maintenance station
for repair
1, u cient gas
2, u cient power or chec the
charger
3, Replace battery
4, It is recommended to use
pedal assist
1, Fastening socket
2,Send to repair station for
replacement
3,Replace fuse
1, eplace new battery
2,Reconnection \fastening
3, end to maintenance station
for repair
1, eplace motorcycle handlebar
and repair lines
2, Timely charging
3, Replace left and right brake handle
4, eplace controller or motor
eplace damaged parts/
maintenance lines
Chec switch position/replace
booster/overhaul line
11