Descargar Imprimir esta página

Parkside PAS 500 D3 Traduccion Del Manual De Instrucciones Originales página 44

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

GB
MT
plastic end piece (with the
printed symbol) into the
hose connection (7) and
screw it tight (bayonet con-
nection).
When assembling/detaching the
suction hose, hold the black plastic
end piece and not the metal suction
hose. Twisting or bending could
damage the hose.
5. Plug the suction tube (12) onto
the rigid end piece of the suc-
tion hose (11).
Switching on/off
Connect the mains plug.
The equipment is fitted with a safety
stop, which allows operation only
with the pleated filter and metal
filter cage installed correctly.
Switching On:
On/Off Switch (see
Switching Off:
On/Off Switch (see
Operating Instructions
The vacuuming of glowing
embers and of materials that
are combustible, explosive or
harmful to health is prohib-
ited. There is a risk of injury!
Place the equipment on a level surface
that is not heat sensitive.
Use the pre-filter (15) when vacuum-
ing fine, cold ashes or dust in order to
44
6) In position "I"
6) In position "0"
protect the metal filter cage (14) and
the folded filter (13) against contami-
nation.
The pre-filter (15) can be removed to
vacuum coarse dirt. This increases the
suction power.
Always use the suction tube for vacu-
uming. In case of minor contamination,
hold the suction pipe approx. 1 cm
above the ash. Remove large ash vol-
umes by directly immersing the suction
pipe.
Vacuum only cooled ash at less than
40°C.
When vacuuming, keep checking the
metal container and suction hose for
rises in temperature.
In the event of a rise in temperature,
switch off the equipment and discon-
nect at the plug. Place the equipment
outside and monitor it as it cools.
During breaks, you can place the suc-
tion hose (
 12) in the suction tube
holder (
 2) on the container lid.
Always use the carry handle (
for transporting the equipment.
The metal container may be filled to
no more than half, so the pleated filter
always remains clear.
Empty the container outside in order
to avoid mess (see "cleaning/mainte-
nance").
Clean the pre-filter (
required, the folder filter (
"Cleaning/Maintenance"):
- if suction power declines
- if the inspection window on the con-
tainer lid of the blockage indication
system (
3) turns red.
4a)
15) and if
13) (see

Publicidad

loading