Quattro CM-071 Guia De Instalacion página 15

Operation - Handset Pairing / Mode Selection
The handset pairing procedure differs depending on the mover configuration you have installed on
your vehicle. It is vitally important that the handset is set up in the correct mode to ensure that the
movers operate as intended. With twin-axle vehicles for example, the turning abilities are of course
very different to that of a single axle. Only by setting the movers up correctly, will you get the best
possible performance out of your mover system.
Familiarise yourself with the handset functions (see 'Operation - Handset Functions) and electronic
control box layout. These will need setting to both the correct model of mover, and the correct mode
for your axle configuration. To set the correct model follow the table below:
Mover Model
QUATTRO600
Quattro Diamond
QUATTRO500
Quattro Rhodium
EGO500
Quattro Platinum
EGO400
Quattro Titanium
EM4446
Ego Enduro
To set up the correct mode, see the following sections:
Single Axle Mode
Ensure batteries are installed into the handset as explained in previous section (Operation - Handset
functions). Turn on isolation switch to provide power to the electronic control unit (2), a solid red LED
will illuminate. Double press the power button (Fig.1.A) to turn on handset.
On your handset (1), press and hold [ENG] (Fig.1.I) and [DENG] (Fig.1.J) for 5 second to enter pairing
mode. The indication LED (Fig.1.B) on your handset should continuously flash green. Press the small
sync button as shown in Fig.3 on your electronic control unit (2). The LED on this box should quickly
flash red, before producing a small clicking noise. The indication LED (Fig.1.B) on your handset should
go solid green, and the LED on the electronics control unit (2) change to a slow red flash to indicate
the two are paired.
Unless changed, the handset will be in Single Axle mode by default. Where the handset is not in the
default mode, press and hold [FL] (Fig.1.E) and [FN] (Fig.1.K) for 5 seconds to select single axle
mode. The handset will bleep once to indicate the mode has been set to single axle. Once set, the
handset and control box will remember their paring, and will be fully operational simply by powering
on.
Pairing Mode:
Selection Description
Hold [FN] (Fig.1.K) and
[R] (Fig.1.H) for 5 seconds.
Hold [FN] (Fig.1.K) and
[F] (Fig.1.C) for 5 seconds.
5 sec
5 sec
5 sec
5 sec
5 sec
EN 15
10 sec
Single Axle Mode:
5 sec
Buttons
5 sec
5 sec
5 sec
5 sec
5 sec
5 sec
5 sec
10 sec
5 sec
5 sec
5 sec
10 sec
5 sec
5 sec
5 sec