Descargar Imprimir esta página

Quattro CM-071 Guia De Instalacion página 21

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 96
Troubleshooting cont.
Rollers slip on wheels - Check that the disengaged distance of the rollers to the tyres is 20mm on
both sides. Check for correct tyre pressure by referring to your caravan manufacturer's handbook. If
the pressure is low, the roller would need to be pushed into the tyre further than usual to gain sufficient
traction.
Rollers not engaging/disengaging (Auto-Engage Models) - Check the polarity of your engagement
wiring (refer to relevant wiring diagrams). If the motor functions but stops short, ensure firstly that
nothing is obstructing any given motor. Where necessary, lubricate the mover and framework to
prevent ceasing.
Indication LED's
Note Indication LED's on both your handset and electronics control unit(s). The following guide can be
used for reference:
Handset:
LED Status
OFF
RED/GREEN Flash
GREEN Flash
RED Solid,Flash,Solid
(accompanied by alarm)
Solid GREEN
Solid RED
Electronics Control Box:
LED Status
OFF
Solid RED
Fast RED Flash
Slow RED Flash
RED Solid,Flash,Solid
(accompanied by alarm
from handset)
Meaning
Handset Off or not receiving power.
Attempting to pair to a previously established connection.
Pairing mode, attempting to establish new connection.
Signal received, system in Operation.
System error:
During set up - Handset has likely been incorrectly set to AWD mode (or
data cable not properly connected, if AWD mode was intended)
During Use - Refer to System Errors table.
On and Paired with control box.
Handset fully reset, all modes set to default
Meaning
Off or not receiving power.
On, receiving power, awaiting pair.
Pairing mode, attempting to establish new connection.
Paired with handset, awaiting commands.
Refer to System Errors Table.
EN 21

Publicidad

loading

Productos relacionados para Quattro CM-071