Publicidad
Idiomas disponibles
Idiomas disponibles
INSIDE MOUNT (IM)
Finished battery installation shown
STEP 3: BATTERY INSTALLATION
•
Attach battery clips to headrail as indicated by "Clip Here" stickers.
•
Snap battery pack into clips with the wire on the left side.
•
Connect battery to motor cable. Loop excess cords into clip on headrail.
STEP 4: INSTALLING THE BLIND
•
Align the headrail and valance with the brackets and slide the headrail straight back
into the brackets.
•
If the headrail can slide from side to side in the box brackets, use a flat-head
screwdriver to bend out the tabs on the ends of the headrail until it is snug.
•
If center support bracket(s) are included, hook the front edge of the headrail
into the channel on the bracket.
•
Lower the front of each box bracket and press until the locking tab clicks into place.
CAUTION: Be sure the brackets are properly engaged before
!
operating the blind. Failure to do so may result in the shade
falling and possible injury.
Home
INSTALLATION
Motorized Tilt Operation
9
Publicidad
