YATO YT-82223 Manual De Instrucciones página 10

PROPERTIES OF THE TOOL
Multi-purpose oscillating tool is a regular electric tool of the 2nd insulation class designed principally for fi nishing works at wood,
plastics and metal processing, particularly in corners and in areas which are diffi cult to reach. The tool permits to cut, grind, clean
surfaces and polish with an adequate insertion tool. Under no circumstances may the tool be used for the purpose of processing
other materials than those mentioned above, e.g. for grinding of fi nishing coats, fi bre-reinforced putty, etc. A correct, reliable and
safe functioning of the grinder depends upon its adequate operation, and therefore:
Before you proceed to use the tool, read the whole manual and keep it.
Attention! Dust generated while grinding certain surfaces may be harmful and even toxic.
The note above regards for example grinding surfaces coated with lead-containing paints, certain kinds of woods, some metals
(e.g. lead) and materials, and therefore during work it is necessary to apply an effi cient dust extraction system, dust masks and
other means of protection of the skin and respiratory system. The supplier shall not be held responsible for any damage due to
failure to observe safety regulations and the recommendations included in this manual.
EQUIPMENT
The tool is provided complete and it does not require assembly, save for installation of the insertion tool described below.
The tool is supplied with accessories.
TECHNICAL PARAMETRES
Parameter
Catalogue number
Mains voltage
Mains frequency
Nominal power
Number of oscillations
Mass
Level of noise
- acoustic pressure L ± K
pA pA
- acoustic power L ± K
wA wA
Class of insulation
Vibration a ± K
h
Grade of protection
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
power tool increases the risk of electric shock.
Do not overload the power cable. Do not use the power cord to carry, pull or unplug the power plug from the power outlet.
Avoid contact of the power cable with heat, oils, sharp edges and moving parts. Damage or entanglement of the power cord
increases the risk of electric shock.
In the case of working outside closed rooms, use extension cords intended for work outside closed rooms. The use of an
extension cord adapted for outdoor use reduces the risk of electric shock.
O R I G I N A L
10
GB
Unit of measurement
[V]
[Hz]
[W]
[min ]
-1
[kg]
[dB(A)]
[dB(A)]
[m/s 2 ]
I N S T R U C T I O N S
Value
YT-82223
230 - 240
50
500
8 000 - 16 000
1,5
106,4 ± 3
117,4 ± 3
II
12,71 ± 1,5
IPX0