Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION OF THE REMOTE CONTROL
Note: If the light is switched on via the wall switch, the unit provides
the lighting scenario that was last set by the remote unit (memory
effect).
INSTALLATION OF THE Wi-Fi LED LAMP WITH FAN
Step 1: Turn off the power and make sure that the cables
are de-energised.
Step 2: Make sure the distance between the floor and
ceiling is at least 2.3m for proper fan operation.
Step 3: Loosen the cap screws on the top of the lamp-
fan to attach it to the ceiling.
Step 4: Pass the wires through the corresponding holes
in the lamp cover.
Step 5: Connect the wires of your old lamp (phase,
neutral and earth) to the terminal strip of the ceiling
lamp.
1.
ON/OFF: the light is switched
on/off.
2.
Night light.
3.
Warm white colour setting
(3000k).
4.
Cool white colour setting (5500k)
Adjustment is made in stages.
5.
Dimmer: brighter.
6.
Dimmer: less bright.
7.
100% brightness (4000k).
8.
Fan on/off.
9.
Wind speed increase (5 gears).
10.
Decrease of wind speed (5 gears).
11.
Forward and reverse switching of
fan blades.
12.
Timer function: 1h, 2h, 4h, 8h,
and cancellation of the timer by
pressing the button for 5s, the fan
beeps for 2 seconds.
5
English
Publicidad
