GETTING STARTED
For key layout on the faceplate, see page 3 or page 4.
1
Cancel the demonstration
When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES]), the display shows:
KD-R992BT/KD-R899BT/KD-R794BT/KD-R792BT:
"CANCEL DEMO" "PRESS" "VOLUME KNOB"
1
Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
KD-R891BT:
"CANCEL DEMO" "PRESS ENTER"
1
Press
.
[YES] is selected for the initial setup.
2
Press
again.
"DEMO OFF" appears.
2
Set the clock and date
1
Press and hold
.
2
Perform 'select an item ( 3 or 4)' operation to select [CLOCK].
3
Perform 'select an item ( 3 or 4)' operation to adjust the clock.
[CLOCK ADJUST]
set the hour and minute
[12H] or [24H]
4
Perform 'select an item ( 3 or 4)' operation to set the date.
[DATE SET]
set the day, month and year
5
Press
to exit.
To return to the previous setting item, press
[CLOCK FORMAT]
.
3
Set the basic settings
1
Press and hold
.
2
Perform 'select an item ( 3 or 4)' operation to select an
item (see the following table).
3
2
Repeat step
until the desired item is selected or activated.
4
Press
to exit.
To return to the previous setting item, press
SYSTEM
KEY BEEP
(Not applicable when 3-way crossover is selected.)
ON: Activates the keypress tone. ; OFF: Deactivates
SOURCE SELECT
AM SRC *
ON: Enables AM in source selection. ; OFF: Disables. ( 6)
SPOTIFY SRC *
ON: Enables SPOTIFY in source selection. ; OFF: Disables. ( 11)
BUILT-IN AUX * ON: Enables AUX in source selection. ; OFF: Disables. ( 8)
F/W UPDATE
UPDATE SYSTEM
F/W UP xxxx
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
FACTORY RESET YES: Resets the settings to default (except the stored station). ;
NO: Cancels.
* Not displayed when the corresponding source is selected.
.
Default: XX
5
ENGLISH