Publicidad
Idiomas disponibles
Idiomas disponibles
4. Press the selection arrow corresponding to " REPLACE
WATER FILTER;";
5. Follow the operations described in the previous section
from point 4.
The filter is now active and you can use the coffee machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.
17.3 Removing the filter
If you want to use the appliance without the filter (C4), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Extract the tank (A16) and exhausted filter;
2. Press the selection arrow (B2) corresponding to the "
symbol (B8) to enter the menu;
3. Press the selection arrow corresponding to "REMOVE
WATER FILTER";
4. "
CONFIRM FILTER REMOVAL": to confirm press the
selection arrow corresponding to " OK" (to go back to
the settings menu, press the selection arrow correspond-
ing to "
ESC");
5. "
FILTER REMOVED": the change has been saved.
Press " OK" to go back to the homepage.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.
18. REGULATORY COMPLIANCE
FCC for USA
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable
protec-tion against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the in-structions, may cause harmful interference to radio
communica-tions. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
"
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician
for help.
IC for CND
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two con-
di-tions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that
may cause undesired operation of the device.
24
Publicidad
