Cembre TW-18B Manual De Uso Y Mantenimiento página 7

IMPORTANT:
The tool is provided with two labels that act as seals on the start buttons. They must only be
removed when the operator, having switched on the tool, presses one of the two buttons with
the resulting rotation of the driveshaft; the "first start-up" will begin a countdown of the days
remaining until the next calibration (See § 9.1.3)
SYMBOLOGY:
Explanation of symbols in the label on the machine (Fig. 2):
Read instructions in this manual before using the tool.
KEEP THESE INSTRUCTIONS: this manual contains important tool safety and operating
instructions for correct use.
During use, keep hands and feet away from the pinch point between the reaction arm and
rail contact surface.
Always wear safety gloves.
Always wear safety footwear.
Mark of compliance with. European safety regulations.
Mark of compliance with UK safety regulations.
Do not dispose of this equipment with ordinary household waste! This equipment must be
disposed of in compliance with the Waste Electrical and Electronic Equipment Directive
2012/19/EU for proper processing and recycling (Ref. to page 24).
Examples of battery compartment label (Fig. 3):
22CM001: tool serial number
2022 - S1K40501: year of manufacture - firmware version
Explanation of symbols used in this manual:
Failure to comply with this instruction may lead to serious physical injury.
Failure to comply with this instruction may cause damage to the equipment or lead to
operating error.
7
EN