Hisense RS840N4WCF Manual De Operación Del Usuario página 17

Filling water
Before you fill the drinking water into the
water tank, ensure that the water tank is
steady and in a correct position.
Caution!
Fill with water up to 3.5L (which is
suggested), and not above the level.
Otherwise, it may overflow when the lid is
close.
We recommend that you fill the water by
the following ways.
Open the small lid by rotating it and fill
water from the inlet of the large lid. please
remember to rotate the small lid back to its
original position when finish filling water.
Small lid
Warning!
Don't touch other parts when filling water,
which may cause water leakage.
Other beverage (milk, juice, carbonated
beverage etc.) were not suggested to be
filled in except for drinking water,
especially beverage including particles
(which may result in function failure).
Hot water was forbidden to be filled into
the water tank.
3
4
Large lid
Head
Receiving water
You should use the correct cups to receive
water underneath the water dispenser.
Dispenser lever
Suggested position
Warning!
Don't push the water dispenser lever
forward without a cup below since it may
cause water spilling.
To avoid cold air leaking out from cabinet,
keep the water dispenser parts (especially
the water storage box and head) still be
installed even if the water dispenser was
out of use.
Cleaning
1. Put the water tank out of the door
carefully, and then wash the tank, lid, and
head lightly in water.
2. After you have successfully cleaned
the appliance, you should dry it by
natural drying or using the dryer.
3. If you have used the water dispenser
for many times, the water in the receiving
tank may drop on the floor, which may
make your floor wet, and you should
clean the tank with dry towel regularly
before overflow.
Bottle rack
It is for storing bottled wine or drinks.
Note:Please use gently when you removed the
bottled wine or drinks.The shelf can be taken
out to be cleaned or you can adjust to save the
shelf space.
Receiving
tank
17