CADstar CS.Neo2 Manual De Instrucciones página 3

1. Safety and general information
This operation manual is structured in accordance with the applicable EU regulations and contains safety instructions. Individuals are
responsible for compliance with safety instructions. This chapter contains a general introduction to the safety instructions. It also contains
important information on accident prevention.
This optical 3D scanner (hereinafter referred to as the scanner), is a state-of-the-art product in terms of safety for operating personnel and
operational reliability. The scanner may nevertheless present hazards if it is used by inadequately trained personnel, or if it is used improp-
erly or not as intended. We refer to possible dangers explicitly in the chapter "Safety and general information, " as well as elsewhere in the
operation manual.
This operation manual contains the relevant information for installation, commissioning, operation, maintenance and disposal of the
scanner.
This operation manual is intended to enable the user to work safely with the scanner.
Observing the instructions in this document will help to avoid hazards and prevent damage to the scanner.
All persons working on and with the scanner must have read the operation manual and observe the information and notes relevant to
them. This operation manual must always be complete and fully legible.
CADstar Technology is not liable for any typographical errors in this manual. Likewise, no liability is assumed for damages that are directly
or indirectly attributable to the delivery. Even after taking the utmost care in the design and construction of the scanner, and even after tak-
ing all issues relevant to safety into account, residual hazards may still exist. These have been evaluated by means of a risk assessment.
This chapter lists all residual risks and warnings from the risk assessment.
The information in this document is subject to change without notice. Every effort has been made in the preparation of this document to
ensure the accuracy of its contents. Any statement, information or recommendation in this document does not constitute a promise of
characteristics of any kind, either expressed or implied.
1.1 Symbols and means of representation
1.1.1 Warnings and additional information
Warnings
The sections marked "NOTE", "CAUTION" and "DANGER" in this document do not include all safety instructions to be followed. They are
only supplements to the general safety instructions. CADstar assumes no liability for any consequences caused by the violation of general
safety requirements or design, production and usage safety standards. This document distinguishes between the following warning levels,
depending on the severity and probability of the danger:
Warning symbol
DANGER
CAUTION
NOTE
1.1.2 Safety sticker on the scanner
Safety instructions are attached to the scanner, which draw attention to possible dangers/residual dangers.
The instructions on the safety sticker on the scanner must be followed under all circumstances. If the safety labels become faded or
damaged during the life of the scanner, they must be replaced immediately with new stickers. They must be checked at regular intervals to
ensure they are
complete and legible. As soon as the signs are not immediately recognizable or comprehensible at fi rst glance, the optical 3D scanner
must be taken out of operation until the new signs are installed.
EN / 2
Description
Indicates a signifi cant hazard that will result in death or serious injury if not avoided.
Indicates a minor hazard that may result in minor injury if not avoided.
A NOTE is used to explain practices that are not related to personal injury or to improve
operations with the product.