CADstar CS.Neo2 Manual De Instrucciones página 6

The operator is responsible for the safe operation of the scanner.
Make sure that only trained, educated or qualifi ed persons work with the scanner.
•
Make sure that every person working on the scanner for the fi rst time has read and understood this operating manual.
•
• Draw special attention to the safety instructions in this manual and on the scanner.
• Keep the operation manual in the area near the scanner and pass it on to new personnel.
• Make sure that no one works on the scanner without having the professional expertise necessary to do so.
• Operating personnel must be instructed at regular intervals on how to work safely with the scanner.
• Please observe national regulations for the protection of female employees.
• When servicing, maintaining or cleaning the scanner, it must be disconnected from the power supply.
Repairs may only be carried out by a certifi ed service agent
•
• Make sure that the notices attached to the scanner when it is delivered remain legible. Missing and damaged warning signs must be
replaced immediately.
1.9 Qualifi cations of personnel
This manual is addressed to the operating and maintenance personnel of the scanner. The operating and maintenance personnel are to be
named by the operator and must have the following qualifi cations:
Maintenance personnel:
• Basic technical knowledge
• Reading and understanding these operating and maintenance instructions is a prerequisite.
The person must be strong enough to lift the unit and place it in its fi nal location.
•
Inspection and cleaning may only be carried out by technical specialists with product-specifi c training or under the guidance of the
•
customer service department
Operators:
• Product training
• Regular safety instruction
1.10 Duties of personnel
• The safety instructions and operating instructions contained in this operating manual must be observed at all times.
This scanner may only be operated by appropriately qualifi ed personnel. These personnel must be familiar with all safety instructions
•
and with the corresponding measures contained in this operating manual and on the scanner for operation, maintenance and clean-
ing.
• The optical scanner must be disconnected from the power supply before cleaning, maintenance and repair work.
1.11 Personal protective equipment
The 3D scanner is designed in such a way that the persons working on the scanner do not require any additional protective equipment
beyond the required standard of the operator (e.g. work clothing, work shoes, etc.).
• Persons performing cleaning and maintenance work must observe the prescribed measures for the corresponding cleaning agents
(e.g. gloves for cleaners; splash protection, etc.).
2. Transport and installation
First of all, check to ensure the packaging is undamaged. If this is not the case, document the damage and contact the seller. Pay attention
to the warnings on the packaging during transport. The device must be transported or stored so that it is well protected, dry and upright in
a package.
In case of longer storage, the device should be stored in a dry place in the original packaging. Care must be taken to comply with the stor-
age requirements as stated in the specifi cation.
5 / EN