Location and Function of Parts and Controls
If you are using the PFM-50C1E with the BKM-B10
(not supplied), and you notice lateral stripes on the
screen, remove the part indicated in the illustration.
Network Adaptor BKM-B30NW (Not
supplied)
The VIDEO connectors are Slot-in connectors. You
can replace the VIDEO connectors with the Network
Adaptor BKM-B30NW.
1
2
3
4
5
1 VIDEO IN connector
Y/C connector (Mini DIN 4 pin): Connect to the Y/
C output connector of an image device.
COMPOSITE connector (Pinjack): Connect to the
composite output connector of an image device.
10
(GB)
2 PC card slot
Install a LAN card or PC memory card as needed.
3 Ethernet connector
Connect to another networked computer with a 10/
Remove this part.
100BASE-T LAN cable.
4 Mouse connector
Connect a USB mouse.
5 Keyboard connector
Connect a USB keyboard.
Note
• This unit is not compatible with the display controls
on the BKM-B30NW. If the controls on the BKM-
B30NW are used, the operation may not be carried
out correctly. Make each setting change from the
unit itself, or using the control button of the RM-971
Remote Commander.
• The settings are made based on the individual signal
formats.
If a signal with a format identical to that of the
BKM-B30NW (1280×768/60Hz) is input to the
INPUT1 and INPUT2 connectors and the settings are
made, these settings will remain in effect when a
switch to the BKM-B30NW occurs.
The same holds true for VIDEO input; the settings
made for the previously connected option board will
remain in effect.
In such cases, change the settings when necessary.