Attaching The Ferrite Core - Sony PFM-50C1 Manual De Instrucciones

Connections

Attaching the Ferrite Core

When attaching to the AC power cord
1
Attach the ferrite cores to both ends of the AC
power cord and close the ferrite cores until they
click.
Within 10 mm ( 13 / inch)
32
2
Wind the stopper round the cord so that the ferrite
cores do not slide.
13
Within 10 mm ( / inch)
32
3
Tighten the stopper and cut the surplus.
16
(GB)
Within 10 mm ( 13 / inch)
32
Within 10 mm ( 13 / inch)
32
When attaching to the cables
1
Attach the ferrite core to the end of the cable
closer to this unit, closing it until it clicks.
2
Wind the stopper round the cord so that the ferrite
core does not slide.
3
Tighten the stopper and cut the surplus.
Notes
• When you connect this unit to various pieces of
equipment using the RGB/YUV connectors, use the
specified cable.
SMF-400 (D-Sub 15P - 5 BNC)
SMF-410 (D-Sub 15P - D-Sub 15P)
When you connect a cable to any of the terminals
listed below, attach the ferrite core provided before
using the cable.
AUDIO (INPUT1)
AUDIO (INPUT2)
• You are cautioned that this unit will not be in
compliance with the EMC limits unless the ferrite
core is installed on the interconnecting wire.
Within 10 mm ( 13 / inch)
32
Within 10 mm ( 13 / inch)
32