Pre-Start Checks; Start & Stop Procedure - Altrad Belle Group AFS 350 Manual Del Operador

Pre start-up inspection.
The following Pre-start-up inspection must be performed before the start of each work session or after every four hours of use, which-
ever is ¿ rst. Please refer to the service section for detailed guidance. If any fault is discovered, the À oor saw must not be used until the
fault is recti¿ ed.
1. Thoroughly inspect the À oor saw for signs of damage. Check components are present and secure. Pay special attention to the
blade safety guard.
2. Check À uid lines, hoses ¿ ller openings, drain plugs and any other areas for signs of leakage. Fix any leaks before operating.
3. Check the engine oil level and top up as necessary.
4. Check the engine fuel level and top up as necessary.
5. Check for fuel and oil leaks.
CAUTION
Stopping the Engine
1. Set the Speed control lever to the low speed
position and allow engine to idle for 1-2 minutes.
2. Raise the blade fully into the blade guard.
3. Turn the engine switch to the O position.
4. Close the fuel cock.
Starting the Engine
1. Open the fuel cock.
2. Set the throttle to the idle position by moving the
throttle lever to the right.
3. Close the choke. If the engine is warm, open
the choke lever halfway, or keep it fully open. If
the engine is cold, close the choke
lever fully.
4. Turn the engine stop switch to the I position.
5. Pull the handle of the recoil starter slowly until resistance is felt. Return the recoil to it's original position and repull swiftly.
6. Do not pull the recoil starter rope fully out.
7. After starting the engine, gradually open the choke until fully open.
8. If the engine fails to ¿ re after several attempts, follow the trouble-shooting guide.

Pre-Start Checks

Start & Stop Procedure
Improper maintenance can be hazardous. Read and Understand this section before you perform any
maintenance, service or repairs.
a
b
c
Honda
a. Speed Control Lever
b. Choke Lever
c. Fuel Cock
9
a
c
Robin
GB
GB
b