Publicidad
Idiomas disponibles
Idiomas disponibles
WATER DRAINAGE METHOD
When there is excess water condensation inside the unit, the appliance stops running and shows "
" (FULL TANK as mentioned in SELF-DIAGNOSIE). This indicates that the water condensation
needs to be drained using the following procedures:
Manual Draining（fig.14)
Water may need to be drained in high humidity areas
1 .Unplug the unit from power source.
2. Place a drain pan under the lower drain plug. See diagram.
3. Remove the lower drain plug.
4. Water will drain out and collect in the drain pan (maybe not supplied ).
5. After the water is drained, replace the lower drain plug firmly.
6.Turn on the unit.
Continuous Draining（fig.15)
While using the unit in dehumidifier mode, continuous drainage is recommended.
1 .Unplug the unit from the power source.
2. Remove the drain plug. While doing this operation some residual water may spill so please have a
pan to collect the water.
3. Connect the drain hose (1/2" or 12.7mm, maybe not supplied ). See diagram.
4. The water can be continuously drained through the hose into a floor drain or bucket.
5. Turn on the unit.
NOTE:
Please be sure that the height of and section of the drain hose should not be higher than that of the
drain outlet, or the water tank may not be drained. (fig.16 and fig.17)
140
Publicidad
